MACHINE PREPARATION
4. HOW TO MOVE THE MACHINE
1. To safely move the machine, you should use a pallet to support it (positioning
wooden wedges to block the wheels, as shown in the previous paragraph).
2. Lower the squeegee (1) by means of the lever or the key (AU version).
3. Use the lever or key (AU version) to lower the base (2) until the brushes are
resting on the floor.
4. Pull the brake lever (3) and block the machine using the pin (4).
5. INSERTING/CONNECTING THE BATTERIES
The machine may be supplied with batteries and a built-in battery charger.
If batteries other than those supplied with the machine are used, have the battery
charger and battery control card configuration checked by a qualified, APEC trained
technician.
Perform a battery charging cycle before using the machine.
The batteries must be housed in the special compartment beneath the recovery tank.
To insert the batteries you must:
1. Lower the squeegee and base (see the appropriate chapter)
2. Release the hinges (1) on the handlebars.
3. Rotate the tank as far as it will go, using the side handle (2).
4. Lift the batteries by means of the grips on the upper part.
5. House the batteries in the compartment, positioning the poles “+” and “-“
opposite each other.
6. Connect the batteries in series - using the jumper cables supplied (3) - to the
poles “+” and “-“.
7. Connect the battery connector cable (4) to the terminal poles “+” and “-“ to obtain
a voltage of 24V on the clamps.
2
1
4
3
ATTENTION
: You are advised to use airtight batteries only, to
avoid the leakage of acids!
ATTENTION
: You are advised to have the electric connections
made by a qualified, APEC trained technician.
to avoid the risk of serious injury
ATTENTION:
You are advised to always wear protective gloves,
to your hands.
ove the batteries
with lifting and transportation means suitable for the specific
weight and size.
ATTENTION:
You are advised to only lift and m
4
3
2
1
8
