CHOOSING AND USING THE BRUSHES
POLYPROPYLENE BRUSH (PPL)
Used on all types of floors. Good resistance to wear and tear, and hot water (no greater
non-hygroscopic and therefore retains its chara
than 60°C). The Polypropylene brush is
cteristics even when working in wet conditions.
ABRASIVE BRUSH
The bristles of this type of brush are charged with highly aggressive abrasives. It is used to clean very dirty floors. To avoid floor
y.
s or floors with small joints.
which can enter the gaps more easily.
id and are no longer able to penetrate
n deep down. In this case, like with over-large bristles, the brush tends to jump.
ing shiny surfaces.
sive floor pad to be held and dragged
central locking system in plastic that
o be perfectly centered and held without any risk of it becoming detached. This type of
dragging device is recommended above all for machines with more than one brush, where the centering of the abrasive
discs is difficult.
TABLE FOR CHOOSING THE BRUSHES
Machine
No.° of brushes
Code
Type of bristles
Ø Bristles
Ø Brush
Length
Notes
damage, work only with the pressure strictly necessar
THICKNESS OF THE BRISTLES
Thicker bristles are more rigid and are therefore used on smooth floor
On uneven floors or those with deep joints, it is advisable to use softer bristles
Remember that when the bristles are worn and therefore too short, they will become rig
and clea
PAD HOLDER
The pad holder is recommended for clean
There are two types of pad holder:
1. The traditional pad holder is fitted with a series of anchor points that allow the abra
while working.
2. The CENTRE LOCK type pad holder not only has anchor points, but also a snap-type
allows the abrasive floor pad t
PE340AS 2
422189
422971
422972
422981
422973
PPL
PPL
PPL
ABRASIVE
CENTER LOCK PAD
0.3
0.6
0.9
1
-
340
340
340
340
330
PAD LOCKING
29
