![Pioneer Eclipse PE340AS Скачать руководство пользователя страница 13](http://html1.mh-extra.com/html/pioneer-eclipse/pe340as/pe340as_operation-manual_1558667013.webp)
14
MACHINE PREPARATION
20. SOLUTION TANK WITH AUTOMATIC CDS DISTRIBUTION SYSTEM
lever and blocking the handle with the pin.
ou open it.
4.
(1) on the handlebars.
5. Rotate the recovery tank as far as it will go, using the side handle (2).
6. Unscrew the cap (3) of the canister in the compartment (behind the batteries)
and fill it with liquid detergent in the manner indicated on the label supplied with the
machine. Check the screw cap is well closed, to avoid any liquid leaking out while
the machine is being used.
7. Close the recovery tank, rotating it by hand. Only hold the recovery tank by the
handle (2), to avoid crushing your hands.
8. Unscrew the front cap of the solution tank and fill with clean water at a temperature
of not more than 50°C. The tank has a maximum capacity of about 55 liters.
To regulate the water/detergent mixture, carefully read the “REGULATING THE
DETERGENT WITH THE CDS SYSTEM” paragraph.
1. Check the switch key is on “OFF”.
2. Apply the parking brake by pulling the
3. Check the recovery tank is empty before y
Release the hinges
1
2
3
ATTENTION:
Put on protective gloves before handling
acid/alkaline detergents or solutions, to avoid the risk of burning
your hands.
ATTENTION:
Always use detergents whose manufacturer's
label indicates their suitability for scrubbing machines. Do not
use acid or alkaline products or solvents without this indication.
In addition, you are advised to always use low foam detergents.
Do not use pure acids or detergents with a stronger gradation
than that indicated on the label supplied.
21. ASSEMBLING THE SPLASH GUARD RUBBERS (BASES WITH DISC BRUSHES)
For packaging reasons, the splash guard rubbers are supplied disassembled from
the machine. To connect the rubber, remove the rubber-pressing blades and
unthread the spring hook (1) from the connection screw. Wind the rubber all around
the base, inserting the base fixing screw in the central hole. Reattach the blades,
starting from the centre of the base.
Be careful not to invert the right blade with the left one, as they are not the same.
1