TROUBLESHOOTING
1. REPLACING THE BRUSHING BASE SPLASH GUARDS
To ensure the water is collected efficiently while the machine is working, you should
iodically check the state of wear and tear of the side splash guards. When you nee
per
d
screws (1) that fix the blocking blade of the splash
2.
splash guard rubber and rotate it by 180° in order to replace the worn
ith
3.
to replace them, proceed as follows:
1. With the base up, loosen the
guard rubber.
Unthread the
part with a new one. If the splash guards are worn on both sides, replace them w
new rubbers (contact the APEC assistance center).
Reassemble everything, carrying out the above-mentioned operations in the reverse order.
ATTENTION
: This operation must be carried out using gloves to
protect against contact with dangerous solutions.
1
2. REPLACING THE SQUEEGEE RUBBERS
Check the state of wear and tear of the squeegee rubbers and, if necessary, replace them.
The rear rubber (1) should be replaced when the squeegee fails to pick up well, leaving
water on the floor. To replace the rubber, you must:
1. Loosen the wing nuts (2) that block the rear rubber-pressing blade and the
strengthening profile.
2. Unthread the rear rubber and replace it (if the rear rubber isn't yet worn, rotate it by
180° and reassemble it so the contact surface is still in good condition).
3. Reassemble the rear rubber, the strengthening profile and the rubber-pressing
blade, then tighten the wing nuts.
1
2
25
