Pima PIMAGUARD, Инструкция по установке и эксплуатации

Страница: 8 / 62

8
Sentinel & PimaGuard
Installation Guide
3. Adjust the transceiver’s output, as described on page 27
Setting the card’s address
The Sentinel’s address is set by a 4-pin dip-switch, located on the PCB.
Figure 3. The card’s address setting dip-switch
The address options are as follows:
Adjusting the transceiver’s output
When connecting a transceiver to the Sentinel, the following should be adjusted:
1. The receiver’s output signal should not exceed 2 Vp-p (Peak-to-peak Voltage). When the 2 Vp-p limit
cannot be met, contact your vendor for support;
2. The receiver’s squelch control should be turned off, i.e., reception signal is not interrupted by the
squelch filter;
P
IMA
G
UARD
I
NSTALLATION
Under Windows XP
©
After installing the Sentinel, when Windows boots up, the ‘Add New Hardware Wizard’ should start running
automatically. If not, go to ‘Start’ -> ‘Control Panel’ and double-click the ‘Add Hardware’ icon, or open the
‘Device Manager’ (‘Start’ -> ‘Control Panel’ -> ‘System’ -> ‘Device Manager’), right-click the device with the
yellow question mark and click ‘Update Driver...’.
Figure 4. The Sentinel as appears in the Device Manager before installing its driver
Color Description Transceiver
Red PTT -
White Sentinel DATA Out Audio input
Green Sentinel DATA In Audio output
Black Volume Volume control
Yellow Shield (GND) Ground
The availabe I/O physical addresses for the sentinel support are: 0C00-FCFF
Two Sentinels cannot have the same address