Pima PIMAGUARD, Инструкция по установке и эксплуатации

Страница: 21 / 62

Sentinel & PimaGuard
Installation Guide 21
L
OGS
Set up the PimaGuard log files.
1. On the left pane, double-click ‘’.
2. Double-click ‘Log 1’.
3. Browse to the location where you want to save the log file #1.
4. Enter a filename for the log and click ‘Open’.
5. In the Log window, click ‘OK’.
Log file size
The Log file size is about 200Mb, depending on the PC available disk size. When the Log file is full, a new Log file
is created and the first file is saved with the suffix ‘old’. When the second file becomes full, the first one is erased.
For the filters list, see page 25.
T
OOLS
Monitor
The Monitor feature has 2 modes: General & debug. To switch between the two, double-click the Mode line in the
right pane. The Debug mode can be operated only with a Sentinel card installed.
Figure 17. The monitor window
General
In this mode, the last 1024 events are displayed (in the right pane). The events are updated online.
Debug
In the debug mode, the incoming & outgoing data are displayed both as raw Hexa frames and as in the General
mode after some processing, to be able to compare the transmissions before and after proccessing.
Filters in this mode, are immediately activated when set, but are not saved when exiting the applicatione. See the
full Filter list on page 25.l
Three failures to write to the log is reported as a fault. See Appendix C, page 28.
The debugging log file size is set as in other logs. (see Logs on the previous section).