Pilous ARG 250 plus S.A.F., Инструкция по эксплуатации, Страница: 16 / 47

Basic functions
MAIN SWITCH
Zapnuto
Vypnuto
TOTAL STOP
Before starting the band drive make always sure that
the band is NOT in contact with the workpiece.
REŽIM
Switch enables modes switching:
enables controlling each function separately
AUTOMAT - In AUT mode automatic cycle is started
MANUAL
-
HYDRAULICKÝ AGREGÁT START - STOP
HYDRAULIC UNIT - START button when pushed togther with main switch switched ON enables the
activating of machine electrical and hydraulic systems.
Activation is signalled by a white signal lamp between buttons 0 - 1
PŘEPÍNAČ ZDVIHU RAMENE
The switch in position 1 automatically lifts the arm of the upper position during each completion of cutting the
material.
The switch in position 0 leaves the arm after finishing cutting the material in the lower end position. This
enables to set the height of the lift of the arm (see Chapter 7.2.).
If the arm is in the lower position or the arm is between cuts, list the arm into the upper position by the switch
into position 1.
PILOVÝ PÁS START/STOP
Red STOP button – serves for stopping the bandsaw engine and pumping the cooling emulsion.
Red button shines – failure of the bandsaw drive (see Chapter 9.)
Green START button
In the AUT mode, the automatic cycle is run – clamping materials, lowering the bandsaw engine and
cooling emulsion pump, hydraulic shift of the arm into the cut, lifting of the arm into the adjusted
position, disconnection of the bandsaw drive and the coolant pump and the release of the clamping
unit. For the functioning of the button, the arm of the saw must be lifted above the clamping route of the
terminal switch for termination of the cut, otherwise the bandsaw drive is not activated.
The bandsaw and the cooling emulsion pump are activated in the MANUAL mode. For functioning of the
button, the arm of the saw must be lifted above the clamping route of the terminal switch for termination
of the cut, otherwise the bandsaw drive is not activated. The clamping unit must be closed.
Emergency stop of the main engine and coolant pump. The
machine restart may be done only after manual unblock of the total
stop button (by pull or turn)