Pilous ARG 250 plus S.A.F., Инструкция по эксплуатации

Страница: 14 / 47

WHEEL HANDLE VICE MOVING BODY FIXED JAW
MOVING JAW
MATERIAL
CONTER NUT ADJUSTING SCREW
OF VICE
WHEEL HANDLE
“T” GROOVE
VICE MOVING BODY
FIXED JAW
MOVING JAW
MATERIAL
SETTING SCREWS “T” GROOVE
CONTER NUT ADJUSTING SCREW
OF VICE
ARG 250 plus S.A.F.
ARG 300 plus S.A.F.
ARG 250 S.A.F.
ARG 300 S.A.F.
5.5.2. Material clamping
The material is clamped with hydraulic cylinder between the vice fixed and moving jaws by the vice moving part. It is not possible to
adjust long pieces with the vice. This operation must be done manually! The clamping vice pressure can be set on the hydraulic unit
according to cut material strength (see chapter 5.7.1.)
Raise the arm above the material expected section. Input the material between the clamping jaws and adjust it to parallel position
with the fixed clamping jaw and set it to requested length. The clamping jaw of the vice must be closed by manual handle by 3 - 8 mm
from the material (the clamping lift of the hydraulic cylinder is 15 mm). According to the mode on which the machine is
MANUAL/AUTOMATIC the vice is clamped.
Check if the material is properly clamped - danger of material shoot out during
cut!
5.5.3. Vice side clearance setting