Pilous ARG 250 plus S.A.F., Инструкция по эксплуатации

Страница: 13 / 47

The machine design enables material cutting under angles without manipulation with the material. The material is fixed between
moving and fixed vice jaws. The setting of requested angle is done by turning the saw arm after lock lever slacking. The arm should be
in down position. The back stop screws stop the arm from turning in the max. Possible angles in types marked as PLUS, the moving
vice body can be moved by slacking the screws in the T groove to left or right side according to arm turning direction.
5.5.1. Cutting angles setting
5.5. Vice
ARG 250 S.A.F., ARG 300 S.A.F.
ARG 250 plus S.A.F., ARG 300 plus S.A.F.
ARM CONTINUOUS
TURNING RANGE
TURNING TABLE
FIXED BACKSTOP OF
ARM TURNING 45°
ANGLE SCALE
ARM LOCK LEVER
SCREW OF ARM
BACKSTOP
END SWITCH
SETTING SCREW
END SWITCH
SETTING SCREW
90° - 60°
ARM TURNING
BACKSTOP 60°
90° - 45° 90° - 45°
90°- 60° 90°- 60°
ARM CONTINUOUS
TURNING RANGE
TURNING TABLE
ARM TURNING
BACK STOP 90°
ANGLE SCALE
ARM LOCK LEVER
ARM BACKSTOP
SCREW
END SWITCH
SETTING SCREW
ARM TURNING
FIXED BACKSTOP 60°