Pilous ARG 105 mobil, Инструкция по эксплуатации

Страница: 12 / 31

4.2. Vice - Workpiece Clamping
Insert the workpiece between the fixed and the movable jaw of the vice so that it is supported by the vice loading surface and
vibrations during cutting are prevented to the maximum possible extent. Before tightening the vice jaw, make sure the workpiece is
inserted parallel with the fixed clamping jaw. You cannot align long heavy workpieces to the correct position by the movable clamping
jaw.
Check whether the workpiece is properly clamped, otherwise you risk its ejection during cutting!
4.3. Cutting Angle Settings
ARG band saws allow for both perpendicular cuts and cuts up to 60 °. The design of the machine allows for angular cutting without a
need to handle the workpiece. The stop bolts facilitate a stable limit angle setting. To set the desired cutting angle, swing the entire
arm and the turntable after releasing the arm swing locking lever or the adjustable table lever. After you set the desired angle (based
on the angular scale), the turntable with the arm will lock using the arm swing locking lever or the adjustable table lever. The desired
arm swing angle will subtract from the angle scale. When swinging the arm, raise it to about 20 mm above the loading surface of the
vice in order to prevent the collision of the saw blade with the loading surface of the vice.
ARG 130 (TK, super), ARG 130 ( K super)
90°- 60°
ANGLE SCALE
ADJUSTABLE
TABLE LEVER
FIXED ARM
SWING STOP 60°
CONTINUOUS ARM
SWING RANGE
TURNTABLE
FIXED STOP
90° ARM SWING
ANGLE SCALE
ARM SWING
LOCKING LEVER
ARG 105 mobil
TURNTABLE FIXED STOP
90° ARM SWING
FIXED ARM
SWING STOP 60°
CONTINUOUS ARM
SWING RANGE
90°- 60°
FIXED JAW MOVING JAW
FIXED JAW
MOVING JAW
4. 4 . Saw Blade Guidance
The saw blade is guided by two guide heads both behind and in front of the cutting line (see the picture in Section 4.6.). The heads are
fitted with eccentrically placed bearings and hardened steel blade guides that allow easier rewinding of the saw blade combined with
the wheel guidance. The fixed guide head is attached to a fixed bar. The movable guide head is attached to a movable bar and moves
to the distance of 5-10 mm from the movable clamping jaw of the vice. Before the cutting, always check whether the movable guide
head and blade cover do not collide with the movable clamping jaw of the vice or with the workpiece within the whole range of arm
descent. The guide bars are fitted with protective covers of the saw blade up to the machining area.
Danger of injury - no cover in the machining area!