Pilous ARG 105 mobil, Инструкция по эксплуатации

Страница: 20 / 31

8 . 3 . Optimum workpiece clamping
Correct workpiece clamping can significantly influence the service life of the saw blade and the cutting accuracy. Moreover, it allows
for correct selection of tooth size. In order to achieve the optimum cut (service life and cutting performance), observe these ways of
clamping.
13x0,65 saw blade
M42/67-69 HRC
80-150
50-100
35-80
50-80
30-50
20-50
0-30
0-20
Material
cross-section
0-10
4z
5/8
6z
6/10
10z
8/12
10/14
14z
Number of
teeth per inch
18z
Manufactured tooth sizes in ARG 105, 130
12
10
8
6
5
4
3
2
Wall
width
(mm)
Pipe diameter (mm)
14
14
14
14
14
14
20 40
14
14
14
10/14
10/14
8/12
6/10
6/10
60 80
14
14
10/14
10/14
8/12
6/10
6/10
5/8
14
10/14
10/14
8/12
8/12
6/10
5/8
5/8
100 120
14
10/14
8/12
8/12
6/10
5/8
5/8
5/8
14
10/14
8/12
6/10
6/10
5/8
5/8
5/8
150
8/12
6/10
6/10
5/8
5/8
5/8
5/8
10/14
8.2 . Selection of Tooth Size
The selection of the tooth size is of crucial importance for the saw blade service life.
Tooth sizes recommended for cutting full materials
The following table refers to piece-by-piece cutting of sectional materials.
Tooth sizes recommended for cutting sections
Rule: At least four, but not more than thirty teeth must cut in while a workpiece is being cut.
Caution: The aforementioned values do not apply to cutting of different sectional materials. Such a requirement must be treated with
respect to the shape of the sectional material, the number of pieces in the bundle and the dimensions. When the saw blade is used for
cutting sectional materials, its service life will decrease by up to one third due to interrupted cutting.