Pilous ARG 105 mobil, Инструкция по эксплуатации

Страница: 6 / 31

1. Transport and storage
DANGER OF DAMAGE !
1.1. Surface Protection
Machine parts are protected against corrosion by powder coating or a primer and two-component polyurethane varnish. Sliding
surfaces are coated with anti-corrosive oil. Surfaces of other parts and components of the machine are treated by galvanization or
blackening.
1.2. Packing
ARG 105 Mobil is shipped in a carton, other types are attached by screws to a EUR pallet which can be adapted as a casing or
overseas box. The distance between the package and the floor is approximately 100 mm, which enables handling and transportation
by a forklift. The machine is packed in a stretching foil that protects it against weather influence during transport.
Standard accessories:
1 bimetallic saw blade M42 (installed),
1 band saw instruction manual,
1 length stop.
1.3. Disassembly/Repacking
Disconnect the machine from the mains • empty and clean the metal chip tank and the coolant tank • clean the machine • apply
anticorrosive oil on the sliding surfaces • fix the arm for transport • lift the machine and screw on the EUR pallet • make sure that all
protective covers of the machine are in place and fastened • add the machine accessories.
Caution: used coolants belong to the category of special waste!
Only a person with adequate electrician qualifications can disconnect the machine
from the mains!
1.4. Disposal
When the machine has been definitely put out of operation, it should be disposed of in accordance with the provisions valid in the
respective country. We recommend that you contact a specialist waste disposal service.
You can transport and lift the machine only with a forklift. THE USE OF A CRANE PROHIBITED!