Pillar UniFoiler 3000, Руководство оператора

Страница: 11 / 39

Installation 5
Installation
Conveyor Coil Support
The coil support is supplied with conveyor mounted coils, and is to be mounted at the spot on the
conveyor system where the sealing is to take place. Normally, this is directly after the capper,
where the bottles will still be spaced apart. Figure 1 shows the components of the coil support
assembly.
Figure 1 – Conveyor Coil Support and Components
Generally, the support's mounting plate can be attached directly to the side of the conveyor.
However, it may be necessary to fabricate a plate or bracket to adapt to a particular conveyor. A
bracket could be made to mount from the floor, if desired. In any case, the installation must be
rigid. If the coil support is mounted directly to the conveyor, bracing of the conveyor may be
necessary to provide sufficient rigidity.
When planning the location of the mounting plate, note that the range dimensions in Figure 8 on
page 30 are given from the bottom of the attachment plate,
not the bottom of the coil. The
thickness of the coil depends on the particular style used. Consider also the range of bottle sizes
that are intended to run under the coil.