Pillar UniFoiler 3000, Руководство оператора

Страница: 21 / 39

Setup 15
Channel Coil
The channel coil is intended for specialty caps such as those with spouts. Channel coils are
designed to fit a specific cap diameter and height. Verify that the coil to be mounted is
appropriate for the type of cap to be sealed.
1.
Note the horizontal scribe marks on each end of the coil. These show the location of the
sealing field. Adjust the vertical crank until these markings are even with the lip of the bottle
where the foil seals as shown in Figure 5.
2.
Loosen the coil mounting clamp lever.
Figure 5
- Adjusting the height of the channel coil
3.
Slide and swivel the coil so that the bottle can pass underneath from one end to the other
without the cap rubbing the sides of the channel.
4.
Firmly tighten the coil-mounting clamp. Make sure that the coil does not swivel during
tightening.
Universal Coil
The universal coil can adapt to a very wide range of cap sizes and shapes. This is accomplished
by angling the coil to the path of the conveyor.
1.
Place a bottle with a cap under the coil. Adjust the vertical crank until there is about 1/8" (3
mm) clearance between the bottom of the coil and the top of the cap. Slide the bottle from
one end of the coil to the other to check the clearance. The clearance should be small, but
enough to ensure that a bottle with a loose or crooked cap will not jam under the coil.