PIAGGIO PORTER 1.3 16V 2008, Руководство по обслуживанию

Страница: 424 / 892

3. Set the ignition switch and the tester main switch
to ON.
4. Check the failure code and frozen image data.
Print or take note. (For the operative procedure,
refer to the user manual).
If the OBD II general scanning device is used, only
failure codes determined by ISO/SAE can be read.
However, DMC failure codes can not be read.
(1) As regards the failure check with 2 interven-
tions (failure code detected only once) not identi-
fied, select the option "continuous monitoring
results" from the menu "vehicle communication" of
the CARB mode, and press the "F1 " key. The
possible failure codes detected are properly indi-
cated.
(2) Also in this case, the OBD II general scanning
device indicates only the failure codes specified by
the ISO/SAE standards. DMC failure codes can
not be read.
5. Once checking has finished, set the tester main
switch and the ignition switch to OFF. Disconnect
the special tool from the data link connector, then
disconnect the tester from the special tool.
N.B.
- IF THE MALFUNCTION PHENOMENA MUST BE REPRO-
DUCED WITH THE DIAGNOSTIC TESTER DS-21 OR OBD II
GENERAL SCANNING DEVICE CONNECTED TO THE DA-
TA LINK CONNECTOR, THE FUNCTION "CONTINUOUS
MONITORING RESULTS" CAN BE USED (IF THE DIAG-
NOSTIC TESTER DS-21 IS USED, SELECT THE OPTION
"CONTINUOUS MONITORING RESULTS" FROM THE
MENU "VEHICLE COMMUNICATION" OF THE CARB
MODE). WITH THIS FUNCTION, THE FAILURE CODE CAN
BE INDICATED WHEN THE MALFUNCTION PHENOMEN-
ON IS REPRODUCED. (REQUEST FOR ON BOARD MONI-
TORING TEST RESULTS ISO 15031-5, CONTINUOUS
MONITORING SYSTEM).
Diagnostic failure code clearing
The failure code and frozen image data can be cleared as follows:
Iniection System
PORTER 1.3 16V
IS - 424