5 Installation
22
Version: 1.1.4
MP155E
V-273 VC Linear Actuator
Requirements
You have read and understood the general notes on installation (p. 17).
You have designed the mechanical mounting, in which the V-273 is installed, so that
collisions are not possible.
When a V-273.441 is used, the mechanical mounting also meets the following
conditions:
−
When the controller is switched on or rebooted,
no
force is applied to the contact
part of the connected force sensors.
−
The contact part of the force sensor (see figure) is oriented orthogonally to the
counterforce that is applied to the runner.
You have provided a suitable surface on the fixed part of the mechanical mounting for
attaching the housing of the V-273:
−
At least three M4 mounting holes are present. For the required position of the
holes, see "Dimensions" (p. 40).
−
The thickness of the surface, the depth of the mounting holes and counterbores, as
well as the length of the screws used, are matched so that the maximum screw-in
depth in the V-273 is adhered to (p. 40).
−
The flatness of the surface is ≤20
µm.
−
For applications with large temperature changes:
The surface has the same thermal expansion properties as the V-273.
You have accounted for the space required to route cables without bending and
according to regulations.
The linear actuator is
not
connected to the controller.
Tools and accessories
If the movable part of the mechanical mounting is to be connected to the runner of the
V-273.440: 1 to 2 M2 screws of suitable length (see "Dimensions" (p. 40))
3 to 5 M4 screws of suitable length (see "Dimensions" (p. 40)) for attaching the housing
of the V-273 to a surface
Suitable tool for tightening the screws
Fixing the movable part of the mounting to the V-273.440 model
1.
Align the runner of the linear actuator in the mounting so that the corresponding
mounting holes in the mounting and the runner are line.
2.
Fix the movable part of the mounting to the holes in the runner of the V-273.
3.
Check that connected parts are fixed firmly.