Phytec Linux-Kit phyCARD-M, Быстрый старт

Страница: 108 / 110

phyCARD-M Quick Start Instructions
104
© 2010 PHYTEC Messtechnik GmbH L-746e_1
You will see the configuration file which holds Barebox’s
environment variables.
•
Make sure the following values are set within the configuration file:
eth0.ipaddr= target IP address
eth0.netmask= target netmask
eth0.serverip= server IP address
•
Type
CTRL-D
to save the settings to the file.
•
If you have made any changes to the Barebox environment, type
save
to
write these changes to the target’s flash. Then press the RESET button
on the target. The board reboots with the new settings applied. Then,
again, press any key to stop autoboot.
•
Type
update_kernel nand uImage-pca101
to download and write the
kernel into the target’s flash.
•
Type
update_rootfs nand root-pca101.jffs2
to download and write the
root file system into the target’s flash.
The copy process can take quite a while, depending on the speed of
your system.
•
Press the RESET button on the board to restart your target.
The target should now start with the kernel and root file system you
have written into the flash.