Phytec Linux-Kit phyCARD-M, Быстрый старт

Страница: 106 / 110

phyCARD-M Quick Start Instructions
102
© 2010 PHYTEC Messtechnik GmbH L-746e_1
You will see the configuration file that holds Barebox’s environment
variables.
The default IP address of the target is 192.168.3.11, and the default server
IP address is 192.168.3.10. If you want to set up a different network
configuration, you can edit the following lines of the configuration file:
eth0.ipaddr= target IP address
eth0.netmask= target netmask
eth0.serverip= server IP address
•
Type
CTRL-D
to save the settings to the file.
•
Type
save
to write the settings to the target’s flash.
•
Press the RESET button on your board. The target will restart with the
new settings applied.
6.3 Restoring the Barebox Default Configuration
If you want to restore the default Barebox configuration, you can use the
following commands to delete the Barebox environment partition:
•
erase /dev/nand0.bareboxenv
After pressing the RESET button on your board, the default Barebox
configuration will be used. This also means that you will be asked to enter
the MAC address of your board again.