Physio Control LUCAS 3, Инструкция для инструктора

Страница: 24 / 80

24
LUCAS
®
3 Chest Compression System
Instructor Guidebook
§
The Release Rings – The Release Rings operate the Claw Locks , which attach the
Upper Part to the Back Plate. These are used for removing the LUCAS device from
the Back Plate. However, before applying the Upper Part, you should pull the Release
Rings once to make sure the claw locks are open, then release the Rings.
It is important you release the Rings when attaching the Upper Part to the Back Plate
so the Claw Locks can click onto the Back Plate. Listen for the click and make sure
the parts are correctly attached by pulling up on the device.
§
Support Leg Strap for the Stabilization Strap – The Stabilization Strap helps secure
the correct position during operation. Apply it while the LUCAS device is active to
keep interruptions to a minimum. Delay the application of the Stabilization Strap if it
prevents or delays any medical treatment of the patient.
§
Once the device is active:
Ÿ
Remove the Stabilization Strap from the Carrying Case and extend the strap fully at
the buckles.
Ÿ
Carefully position the cushion of the Stabilization Strap behind the patient’s neck,
as close to the patient’s shoulders as possible.
Ÿ
Connect the Buckles on the Support Leg straps to the Buckles on the Stabilization
Strap. Make sure straps are not twisted.
Ÿ
Hold the LUCAS device Support Legs stable and tighten the Stabilization Strap.
Only tighten as much as needed to secure the device. Be careful not to pull the
device out of position.
Instructor Notes:
Point to the Claw Locks and demonstrate opening a closed Claw Lock by pressing one
side closed, and pulling the Release Rings once to demonstrate opening the
Claw Locks.
Instructor Notes:
Attach the Upper Part of the LUCAS device to the Back Plate. In the next section you will
demonstrate the too small patient alarm and explain the control panel.