NOTE:
If you have an object that is 100 cm3 then it will use
115g of resin. Always overfill by at least 20% to ensure
consistent resin flow. For most prints, filling the vat to
1/3 full is more than enough. Place the hood back on
the printer.
11
12
NOTE:
You can check the screen is working in the “Control”
tab ; by activation manual Gcode, writing M106 in com-
mand bar, pressing send (backlight should come on at
this stage), pressing the “Show calibration” button lo-
cated and a blue grid will appear.
To turn off the backlight, send M107 command.
Now you have set up your printer, lets make your
first print!
3. STARTING A
TEST PRINT
STARTING FROM CREATION
WORKSHOP
Please download the CrossRings test file from the
Liquid Crystal Precision support page. In Creation
Workshop, click on the “Open” button in the
top left and open the file “CrossRings x5”. Please
note this file is very large and depending on your
computers processing power this make take few
seconds to open up. Press the “Print” button.
PRECISION
PRECISION
