Philips M3000A, Руководство по обслуживанию

Страница: 231 / 293

Troubleshooting the Recorder Connection
Troubleshooting the Instrument 215
Troubleshooting the Recorder Connection
Here is a list of some easily corrected troubleshooting cases. See also page 195, and the
Operator’s Manual of the XE-50p Chart Recorder.
If printing via a network link—
Make sure that the printer is connected to the
Philips LAN or the M3 Print Server
a
network (see
Connecting a Remote Printer in "Installing the
Instrument").
Make sure that the printer is switched on.
Data is missing from a print-
out and the printout is at
lower resolution than normal The laser printer was switched off, but the Jet-Eye
was left on. This results in the described
behaviour. Users should be advised always to
switch the printer and Jet-Eye off together.
Your printout is too big for
the page: This can happen if the JetEye is switched on but
the printer is switched off when you start printing.
Make sure both the printer and, if necessary, the
JetEye are switched on, then print again.
A
REMOTE PRINTER
NOT AVAILABLE
mes-
sage appears on the screen:
Check that the Monitor is connected to the Philips
LAN or the M3 Print Server
a
network.
If it is not, connect it (see Connecting a Remote
Printer in "Installing the Instrument").
If it is connected, contact the M3 Print Server
system administrator
b
.
The printout does not appear
at the network printer but
there is no error message at
the Monitor: Check that the network printer is switched on and
not in an error condition.
If it is both switched on and in an error-free
condition, contact the M3 Print Server system
administrator.
b
a. No longer available.
b. If applicable.
Message What To Do
You cannot find the record
softkeys. Make sure that the Recorder is configured (see
“Connecting a Local Recorder” on page 96).