Philips HTS3251/12, Быстрый старт

Страница: 24 / 32

22
EN
Subwoofer
•
Output power: 150 W RMS (30% THD)
•
Impedance: 8 ohm
•
Speaker drivers: 165 mm (6.5") woofer
•
Dimensions (WxHxD): 195 x 265 x 265 mm
•
Weight: 3.20 kg
Speakers
•
Output power: 2 x 75 W RMS (30% THD)
•
Speaker impedance: 4 ohm
•
Speaker drivers: 1 x 63.5 mm (2.5") woofer
• Dimensions (WxHxD): 84.5 x 159 x 80 mm
•
Weight: 0.35 kg/each
Remote control batteries
•
2 x AAA-R03-1.5 V
Laser
•
Laser Type (Diode): InGaN/AlGaN (BD),
AlGaInP (DVD/CD)
•
Wave length: 405 +7 nm/-7 nm (BD), 655
+10 nm/-10 nm (DVD), 790 +10 nm/-20 nm
(CD)
•
Output power (Max. ratings): 20 mW (BD),
6 mW (DVD), 7 mW (CD)
8 Troubleshooting
Warning
•
Risk of electric shock. Never remove the casing
of the product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check
the following points before you request service. If
you are still having problems, get support at www.
philips.com/support.
Main unit
The buttons on the home theatre do not work.
•
Disconnect the home theatre from the power
supply for a few minutes, then reconnect.
Picture
No picture.
•
Make sure that the TV is switched to the
correct source for the home theatre.
No picture on a TV connected through HDMI.
•
Make sure that the HDMI cable is not faulty. If
it is faulty, replace it with a new cable.
•
Press (
Home
) and then
731
on the remote
control to restore the default picture resolution.
• Change the HDMI video setting, or wait for
10 seconds for auto recovery (see 'Picture
and video settings' on page 16 ) .
Disc does not play high-de fi nition video.
•
Make sure that the disc contains high-
de fi nition video.
•
Make sure that the TV supports high-
de fi nition video.
• Use an HDMI cable to connect to the TV.
Sound
No sound from home theatre speakers.
•
Connect the audio cable from your home
theatre to your TV or other devices. You do
not need a separate audio connection when
the home theatre and TV are connected
through an HDMI ARC connection.
•
Set up the audio for the connected device
(see 'Set up the audio' on page 9 ) .