Philips HTB4520, Руководство пользователя

Страница: 22 / 46

20
EN
Note
•
AM and digital radio are not supported.
•
If no stereo signal is detected, you are prompted to
install the radio stations again.
1
Connect the FM antenna to the
FM
ANTENNA
on your home theater.
• For the best reception, place the
antenna away from your TV or other
sources of radiation.
2
Press SOURCE repeatedly to switch to
radio source.
»
If you have already installed the radio
stations, the last channel that you
listened to is played.
» If you have not installed any radio
stations, the message
AUTO
INSTALL...PRESS PLAY
appears on
the display panel. Press (
Play
) to
install radio stations.
3
Use the remote control to listen or to
change radio stations.
Play buttons
Button Action
/
or
Alphanumeric
buttons
Select a preset radio station.
Navigation
buttons
Left/Right: Search for a radio
station.
Up/Down: Fine tune a radio
frequency.
Press to stop the installation of
radio stations.
Press and hold to erase the
preset radio station.
Button Action
Manual:
1) Press .
2) Press / to select your
preset.
3) Press again to store the
radio station.
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
SUBTITLE
/
AUDIO
Toggle between the stereo and
mono sounds.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz.
1
Press SOURCE repeatedly to switch to
radio source.
2
Press .
3
Press and hold ( Play ) to toggle between
50 kHz or 100 kHz.
External audio device
Connect an external audio device to play audio
files.
What you need
• An external audio device with 3.5mm jack.
• A 3.5mm stereo audio cable.
1
Using the 3.5mm stereo audio cable,
connect the external audio device to
AUDIO IN
the connector on your home
theater.
2
Press SOURCE repeatedly until AUDIO
IN appears on the display panel.
3
Press the buttons on the external audio
device to select and play audio files.