6
1. Use different specifications of installation kit according to door thickness
2. The default installation kit applies to door thickness of 60 to 90 mm.
If the door thickness is not within this range, please contact us.
Step 3 | Change the direction of the latch bolt
You can change the direction of the latch bolt to adjust to
different door opening directions: outward bevel for inward
opening and inward bevel for outward opening.
Latch bolt
Directional screw
Latch bolt reversing tailpiece
1. Push the reversing tailpiece upwards to the top
2. Press the latch bolt into the mortise and
rotate it 180 degrees. Then pull it out
3. Push the tailpiece downwarads to the bottom
4.
Change the direction of the screws
depending on your needs
(The directional
screws must be fixed on the inside of the door,
namely towards the inner unit of the lock)
1
Use the drilling template
to drill the needed holes
on the door and mount the
mortise into the door.
When you insert the mortise,
connect it with the upper and
lower multi lock points (No
such step on wooden doors).
2
Installation steps
The following installation steps apply to right opening doors. For
left opening type, please read the [Pre-installation Instructions]
carefully and complete those necessary reversing operations.
Attention
