Philips 32PFL7332/93, Руководство по обслуживанию

Страница: 15 / 109

Mechanical Instructions EN 15 LC7.1A LA 4.
4.3.7 Small Signal Board (SSB)
1. Remove the rear cover, as described earlier.
2. Refer to figures “SSB removal“ below.
3. Disconnect all cables [a] on the SSB.
4. Remove the T10 tapping screws [b] that hold the SSB. See
Figure “SSB removal”.
5. Remove the screws that hold the CINCH and HDMI
connectors at the connector panel.
6. Lift the SSB from the set.
Figure 4-15 SSB removal -1-
Figure 4-16 SSB removal -2-
4.3.8 Main Supply Panel
1. Remove the rear cover, as described earlier.
2. Refer to fig. “Main supply panel“ below.
3. Unplug cables [a].
4. Remove the fixation screws [b].
5. Take the board out (it hinges at the left side).
Figure 4-17 Main supply panel
4.3.9 AmbiLight Interface Panel (where applicable)
1. Remove the rear cover, as described earlier.
2. Refer to fig. “AmbiLight interface panel” below.
3. Unplug the LVDS connectors [1]. Be careful as they are
very fragile.
4. Unplug the remaining connector [2].
5. Remove the fixation screws [3] and take the board out.
Figure 4-18 Ambilight interface panel
4.3.10 AmbiLight Unit (where applicable)
1. Remove the rear cover, as described earlier.
2. Refer to fig. “AmbiLight unit” below.
3. Unplug the connectors [1].
4. Remove the screws [2] and slide the unit sideways out of
the back cover.
H_17260_036.eps
050707
a
a
b (2x)
b (3x)
b (3x)
b (2x)
H_17260_037.eps
050707
b
b b b b
G_16860_065.eps
010207
a
a
a
b (3x)
H_17270_014.eps
060707
1
2
3
3