34
TEMPERATURE RECORDER (OPTION)
Temperature recorder unit of MTR-G85C
1. Cover button:
To open the cover, pull the cover forward while pressing the cover button.
2. Key lock:
Insert the enclosed key and turn to the right while pushing and the cover is locked.
3. Pen cap holder:
The pen cap that is removed when loading the pan cartridge can be placed on this
holder.
4. Recording chart:
Circular chart with an outer diameter of 155 mm. Always use the specified chart.
5. Chart guide:
These guides are used to hold down the recording chart. One guide is located at the
bottom-left side.
6. Back-up battery:
An Ni-MH battery is used as a back-up power source. In the event of power
failure, the temperature recorder is operated with this battery. The back-up operation is about 24 hours.
7. Chart hub cover:
This cover is used to hold the recording chart. The recording chart does not feed
properly unless this hub cover is present.
8. Power switch:
This switch is used to turn the power ON and OFF.
9. Pilot lamp:
A green light is seen through the recording chart when the power is ON. This lamp will
not turn ON when the temperature recorder is being powered by the back-up battery.
10. Chart speed selector:
This selector is used to set the time for one full chart revolution (1, 7 or 32
days).
11. Zero adjustment screw:
This screw is used to align the pen tip recording value with the previously
set value.
12. Fast feed button:
This button is used to set the loaded chart to the correct time. The speed is 10
minutes/revolution.
Due to the structural design, 2 to 3 seconds may be required before movement starts, even when
pushing this button.
13. Pen cartridge:
The cartridge is red. The pen life is approximately 6 months.
14. Pen lifter:
Turn clockwise to raise the pen. This function helps to prevent the recording chart from
becoming marked when it is removed or when loading a pen cartridge.
15. Pen lifter stopper:
The pen lifter is place at this stopper position during recording operation.
16. Pen arm:
The accessory pen cartridge is attached to this arm.
1
2
3
5
6
7
4
8
9
10
11
12
14
15
16
13
Содержание MDF-DU300H
Страница 2: ......
Страница 11: ...9 FREEZER COMPONENTS Freezer unit 14 Rear side 17 10 Inside 1 2 8 9 3 4 5 11 12 14 6 6 7 13 POWER 16 15...
Страница 47: ......
