ASSEMBLY INSTRUCTIONS
•
STEP II: See Images Below
VERY IMPORTANT: the knob must be removed first, otherwise
the side burner can’t be installed in next step.
1.
Side Burner Hose is preassembled to gas manifold. Pull hose with side burner
valve already attached through hole in side wall of cart (square hole in right hand
panel of cart assembly).
2.
Remove the packing materials. Use the provided hexagon wrench (Allen) to
loosen (don’t remove)
the setscrew on the control knob, and pull out the knob.
3.
Remove the two M4*6 screws from front of side burner valve.
4.
Remove the two screws on side burner bracket A, which hold side burner in place,
remove side burner, to allow side valve to be mounted.
5.
From underneath side shelf, place side burner valve steam to through opening on
front of side burner control panel. Attach and secure side gas valve to control
panel using the M4*6 screws.
6.
Slightly insert Side Burner onto tip of gas valve make sure it’s centered. Replace
and tighten the two screws on bracket A.
7.
Attach igniter wire with red sleeve to valve electrode.
8.
Place and press control knob onto valve steam, and tighten the setscrew of knob.
1
2
3
4
5
Remove two screws
securing burner in place
on Burner Bracket “A” will
use again in Step 6.
Loosen set screw to be able
to remove knob using
provided Allen wrench-DO
NOT FULLY REMOVE Screw.
Remove two screws
from valve assb. Will
use again on Step #5
