Pfeiffer Vacuum HILOBE 1002, Руководство по эксплуатации

Страница: 37 / 68

7 Parameter set
7.1 General
Important settings and function-related characteristics are factory-programmed into the electronic drive
unit as parameters. Each parameter has a three-digit number and a description. The use of the parame-
ter is possible via Pfeiffer Vacuum displays and control panels, or externally via RS-485 using Pfeiffer
Vacuum protocol.
The vacuum pump starts in standard mode with factory default pre-set parameters.
Non-volatile data storage
When switching off or in the event of unintentional voltage drop, the parameters and the
operating hours stay saved in the electronics.
# Three digit number of the parameter
Display Display of parameter description
Description Brief description of the parameters
Functions Function description of the parameters
Data type Type of formatting of the parameter for the use with the Pfeiffer Vacuum protocol
Access type R (read): Read access; W (write): Write access
Unit Physical unit of the described variable
min. / max. Permissible limit values for the entry of a value
default Factory default pre-setting (partially pump-specific)
The parameter can be saved persistently in the electronic drive unit
Tbl. 8: Explanation and meaning of the parameters
7.2 Control commands
# Display Designations Functions Data
type
Ac-
cess
type
Unit min. max. de-
fault
002 Stand-by Stand-by 0 = off
1 = on 0 RW 0 1 0
009 ErrorAckn Malfunction ac-
knowledge-
ment
0 W 1 1
010 PumpgStatn Pump 0 = off
1 = on 0 RW 0 1 1
013 BrakeOn Activate brak-
ing resistance
0 = off
1 = on 0 RW 0 1 1
019 Cfg DO2 Output DO2
configuration
1 = No error
2 = Error
5 = Set rotation speed
reached
6 = Pump on
9 = "0"
10 = "1"
11 = Remote priority active
7 RW 0 20 6
024 Cfg DO1 Output DO1
configuration
Settings, see [P:019] 7 RW 0 20 1
026 SpdSetMode Speed actuator
operation
0 = off
1 = on 7 RW 0 1 0
Parameter set
37/68