Pfaff 8304-040, Инструкция по эксплуатации, Страница: 27 / 52

Setting up
9 - 4
9
.04
Hot-air pressure, hot-sealing temperature, -pressure and -speed
●
Switch the machine on.
Hot-air pressure:
●
Adjust hot-air pressure on regulator 1 depending on the workpiece (at least 0.3 bar ).
●
To adjust the hot-air pressure on regulator 1 first set the pressure at “0”. Then adjust
regulator 1 to the required level.
Before switching the main switch on, make sure that the hot-air pressure is
higher than 0.2 bar !
If the hot-air pressure is too low, the heating switches off automatically.
Heat-sealing temperature:
●
Adjust the heat-sealing temperature on the buttons 2 depending on the material (max.
650°C ).
●
Display 3 shows the required temperature and display 4 the actual temperature.
Heat-sealing speed and feed roller pressure:
●
The heat-sealing speed and feed roller pressure depend on the material and can be
adjusted as described in Chapter 7.07 or 7.10.
1
Fig. 9 - 07
2
4
3
Fig. 9 - 06
From
the
library
of:
Diamond
Needle
Corp