Pfaff 8304-040, Инструкция по эксплуатации, Страница: 25 / 52

Setting up
9 - 2
Switch the machine off and let it cool down!
Danger of burns if the hot-air nozzle is touched!
●
Fit the tape reel on the tape reel bracket.
Machines without tape trimming device
●
Cut the tape at a slant so that it is easier to insert.
●
Insert the tape into guide 1 and pull it through up to the feed rollers.
●
Adjust guide pin 2 (screws 3 ) in accordance with the requirement 1 .
Machines with tape trimming device
●
Cut the tape at a slant and insert it as far as possible into guide 4 .
●
Switch on the machine.
●
Trigger a band trimming operation (see Chapter 7.0.3).
●
Adjust the guide with screw 5 in accordance with the requirement 1 .
If the tape is not drawn in straight, switch off the machine and pull the tape in
with tweezers.
●
Loosen bolt 6 and adjust the tape brake 8 with screw 7 according to requirement 2 .
9
.01.02
Inserting the heat-sealing tape / Adjusting the tape width and the tape brake
Requirement
1. The sealing tape should run easily through the narrow guide section.
2. The tape should run easily from the reel, but not be slack.
Fig. 9 - 02
6
7
8
5
Fig. 9 - 03
3
2
1
4
From
the
library
of:
Diamond
Needle
Corp