MISCELLANEOUS OPERATIONS
Page: 36
Reproduction or translation, even partial, forbidden without the written consent of Peugeot Motocycles
Disassembly
- Remove the 2 nylon washers (12 and 13) located
at each end of the stub
- Tighten tool P/N 750411 in a vice
- Fit the governor (1) on the tool
- Locate the bobweight mounting plate (1D) in the
tool 4 pegs
- Fold down the nut locking tab (1J)
- Remove the 32 mm nut (1K)
- Remove the fixed (1A) and rotating (1G) flanges
- if necessary, unclip the moving flange (1G) drive
system (1H) using a screwdriver
Types 2 and 3
- if necessary, remove each bobweight by
removing the spindle locking device and spindle
(1F)
Re-assembly
Proceed in reverse order to disassembly
Note:
tighten the 32 mm nut to the recommended
torque and close the washer locking tab
