REASSEMBLY
Page: 20
Reproduction or translation, even partial, forbidden without the written consent of Peugeot Motocycles
To fit the crank assembly in the LH casing
Special tooling required
- Casing extraction and opening tool P/N 64706
- Butterfly nut P/N 60104
- Shouldered centring tool P/N 64710
- Pin Ø 11 mm pitch 100 P/N 64754
- Pin Ø 10 pitch 125 P/N 64754 750069
- Casing opening/closing bush P/N 69137
- Taper dowel for seal P/N 69143
- Casing opening/closing plate P/N 750369
- Fit the magneto flywheel, this will act as a support
Fit dowel P/N 69143 to the crank assembly to prevent
damage to the seal
- Fit the crank assembly inside the bearing
- Fit bush P/N 69137 the small diameter side against
the casing
- Tighten pin P/N 64754 against the end of the crank
assembly
Note:
for kickstart engines use pin Ø10
pitch 125 P/N 750069
- Fit tool P/N 64706 fitted with plate P/N 750369 over
bush P/N 69137
- Centre assembly with 2 nuts and bolts (5)
Ø 6 x 80 mm
- Fit the shoulder centring tool P/N 64710 and
butterfly nut P/N 69104 to tool P/N 64706
