REASSEMBLY
Page: 19
Reproduction or translation, even partial, forbidden without the written consent of Peugeot Motocycles
To fit the bearing and seal in the RH casing
Special tooling required
- Bearing fitting tool P/N 69111
- Fitting guide P/N 69115
- Fitting guide P/N 69112
- Fitting guide P/N 69113
- Bearing guide and crank assembly seal P/N 69114
Note: the tools and parts should be prepared
before the operation
after heating the casing half, the work must
proceed quite quickly
- Heat the casing half to 80 to 90°C
- Fit guide P/N 69112 (Ø 16 mm) into base P/N 69111
- Fit the casing half (with mating surface upwards) on
tool P/N 69111
- Fit the seal guide P/N 69113 (the knurled side facing
upwards) into the bearing bore
- Fit the previously greased seal to guide P/N 69112
(the lip facing upwards)
- Push the seal fully home into the casing using tool
P/N 69114 (small diameter side)
- Remove the tool P/N 69114 and seal guide P/N
69113
- Without removing the casing from the base, remove
the guide P/N 69112 (Ø 16 mm) from the top and in
its place, through the seal, fit guide P/N 69115 (Ø 17
mm)
- Fit the bearing to guide P/N 69115 and push it fully
home into the casing using tool P/N 69114 (large
diameter side)
