www.petsafe.net
11
GET
TING ST
AR
TED
GET
TING ST
AR
TED
To install the clock battery:
Remove the clock battery
cover from the back of the interior frame. Insert the battery
with the positive (+) side facing the right side of the battery
slot. Make sure battery is fully inserted. Reinsert battery
cover and push to snap into place.
To install the power adapter:
The PASSport Pet Access Smart System
™
is supplied with a
low-voltage AC adapter for power. Insert the power adapter
into the power connection located underneath the
bottom of the interior frame.
An optional rechargeable Lithium battery is available to use
with the PASSport
™
(sold separately, see “Replacement Parts
and Accessories”). If using the PASSport
t™
Rechargeable Battery instead of the adapter for the power source, insert it into the
battery compartment on the right side of the interior frame (see the “PASSport
™
Rechargeable Battery Operating Guide” on
how to insert the rechargeable battery).
Check PASSport
™
Location
Go to the location where you plan to install the PASSport
™
. Place the PASSport
™
directly in front of the door or application
in the upright position. If using the supplied power adapter, find the closest power outlet. Plug in the adapter to power
up the pet door. The power adapter cord is 6’ in length. If the power adapter will not reach the closest outlet, you will
need a power cord extension, to instead use the optional PASSport Rechargeable Battery
™
(both sold separately, see
“Replacement Parts and Accessories”) or to find an alternative location to install the PASSport
™
.
Prior to installation, it is recommended to set-up, test and program the PASSport
™
Pet Access Smart System in the intended
location or application to check for possible radio-frequency interferences. These interferences could negatively affect
the PASSport
™
from working properly and receiving the signal of the PASSport Key
™
. Common household appliances and
electronic products should be located at least two feet (60 cm) away from the location of where the PASSport
™
will be
installed. Typical household products to consider are microwaves, televisions, wireless telephones, computers, garage
door openers and hand-held electronic devices such as remote controls or game stations. Keep the PASSPort
™
in front of
the door or application in the upright position and proceed to the
next steps to continue to check for radio-frequency interferences.
It is recommended to install the PASSport™ in a location where
direct sun in not a factor. Operating temperature range: 5°F to
131°F (-15°C to 55°C).
Prepare PASSport Key
™
A PASSport Key
™
is required for your pet to be programmed to and access the PASSport Pet Access Smart System
™
. One
PASSport Key
™
is included. Additional PASSport Key
™
’s are available for multiple pet households (sold separately, see
“Replacement Parts and Accessories”). The PASSport
™
can be programmed for up to 20 PASSport Key
™
’s or pets. Attach
the PASSport Key
™
to your pet’s collar using the included split key rings. For best results, attach the PASSport Key
™
to the
front of your pet’s collar. It should hang under your pet’s neck and parallel to the flap so the PASSport
™
can read the key.
Initial User Setup
Have your pet nearby wearing the PASSport Key
™
before beginning the “Initial User Setup” steps. Programming
your pet is time sensitive with 30 seconds for the PASSport
™
to read your pet’s PASSport Key
™
.
Pull and lift
here
