Permobil BodiLink Lateral Trunk Support, Руководство по эксплуатации

Страница: 7 / 80

BodiLink Lateral Trunk Support Operation Manual
5
PREMIUM SUPPORT PAD ATTACHMENT
For GT2 hardware styles. All required tools are provided.
1
If the support pad (E) has a cover, start by pulling back
the cover flap to expose the holes in the support pad.
Line up the bolts (B) and the safety washers (C) with the
short slots on the hardware link (D) and the holes inside
the support pad (E). The flat face of the link (D) must face
the support pad.
2
Tighten the bolts (B) using the 4mm hex key.
Note: Follow these instructions if the support pad is already
attached to the hardware assembly (A), and depth adjustment
of the support pad is needed:
1
Pull back the cover flap. Loosen but do not remove the
bolts (B) using the 4mm hex key. Slide the support pad (E)
into position.
2
Tighten the bolts (B) with the 4mm hex key and release
the cover flap.
Premium Pad Orientation: The Supportive Pad and Active
Pad are shaped differently. If changing from one to the
other support pad type, switch the left and right side pads
when mounting.
Supportive Pad Active Pad
Swing-Away GT2 Hardware and
Supportive Shape Premium Support Pad
Note: The LTS support pad cover is not shown but may be
included with the support pad. See “Cleaning” for cover care.
A
E
D
C
B
BASIC SUPPORT PAD ATTACHMENT
For GT2 hardware styles. All required tools are provided.
1
The support pad (F) is provided with the cover on. Pull
back the cover flap to line up the bolts (B) and the safety
washers (C) with the short slots on the hardware link (D)
and the threaded holes on the double nut (E) inside the
support pad (F). The flat face of the link (D) must face the
support pad.
2 Tighten the bolts (B) using the 4mm hex key.
Note: Follow these instructions if the support pad is already
attached to the hardware assembly (A), and depth adjustment
of the support pad is needed:
1 Pull back the cover flap. Loosen but do not remove the
bolts (B) using the 4mm hex key. Slide the support pad (F)
into position.
2
Tighten the bolts (B) with the 4mm hex key and release
the cover flap.
Support Pad Orientation: Supportive shape pads are
symmetrical from top to bottom. Active pads should be
oriented with the sloped edge along the top.
Supportive Pad Active Pad
A
E
F
D
C
B
Swing-Away GT2 Hardware and
Supportive Shape Basic Support Pad
Note: The LTS support pad cover is not shown but is included with
the support pad. See “Cleaning” for cover care details.