Perlight Solar IRT Integrated Roof Tile Installation Manual
12
www.perlight.com
V.03.2021 C2.6
Installation Steps (Example)
Placement of additional modules
After the first module (1-1) is fixed, you can continue to
install the next module of the same row.
PLM-**MB-24 (M) (1-2) should be used in the middle
section only.
Note that when the end of the row is reached, the
rightmost module must be PLM-**MB-24 (R) (1-3).
We suggest that two installers carry the module
by holding two sides.
Insert the Male Edge of the
second module into the Female Edge of the first
module as shown in the picture.
At the same time, lock the Lower Frame of this
module with the clamp slot of the Bottom Edge.
Lay the module down and slide down into position.
Check the placement to make sure the whole frame
is in place and the module is placed flat. Because the
frame will slide down naturally, there may still be room
between Lower Frame and Bottom Edge slot, and
slight mismatches between the second module and
the first module as shown in the picture. Pull down the
second module to make the Lower Frame insert into
the Bottom Edge slot.
To ensure alignment of the upper and lower parts of
joining modules, a rubber hammer can be used to tap
the Upper Frame of the module. Use a wooded strip
with equal length to the module against the module
edge and
gently tap
into final position.
Do not strike
with excessive force and do not strike the front
side of the module.
