Perkins 1300 EDi Series, Руководство по ремонту, Страница: 203 / 264

13
Workshop Manual, TPD 1353E, Issue 3 191
Peregrine EDi and 1300 Series EDi
Flywheel housing
To remove and to fit Operation 13-4
Warning! The flywheel housing weighs 33,5 kg (73.87 lbs). Use lift equipment or obtain assistance to lift the
flywheel housing.
To remove
1 Remove the starter motor, see Operation 14-3.
2 Remove the flywheel, see Operation 13-1.
3 Release the housing setscrews and remove the housing.
4 Remove and discard the camshaft ’O’ ring, from the rear face of the crankcase.
To fit
1 Ensure that the rear face of the cylinder block and the faces of the housing are clean and free from damage.
2 Fit a new camshaft ’O’ ring into its recess in the rear face of the crankcase.
3 Fit the housing (B2) and tighten lightly the setscrews.
4 Check the housing run-out (B) with a dial test indicator (B1) at the 3 o’clock, 6 o’clock, 9 o’clock and 12
o’clock positions. The maximum tolerance is given in the relevant Data and dimensions for the "Flywheel and
housing" on page 18. If any adjustment is necessary, it must be made on the housing and the run-out checked
again.
5 Tighten the setscrews to 136 Nm (100 lbf ft) 13,8 kgf m.
6 Check the housing alignment (A) with a dial test indicator (A1) at the 3 o’clock, 6 o’clock, 9 o’clock and 12
o’clock positions. Ensure that the crankshaft is pushed fully toward the front of the engine for each
measurement. The maximum tolerance is given in the relevant Data and dimensions for the "Flywheel and
housing" on page 18. Any necessary adjustment must be made on the housing and not on the cylinder block.
7 Fit the flywheel, see Operation 13-2.
8 Fit the starter motor, see Operation 14-3.
W074
A
1
W073
B
1
2
This document has been printed from SPI². Not for Resale