Perkins 1300 EDi Series, Руководство по ремонту, Страница: 149 / 264

10
Workshop Manual, TPD 1353E, Issue 3 137
Peregrine EDi and 1300 Series EDi
To fit Operation 10-10
Special requirements
Note: Manufacture locally, four guide dowels. Use the dowels to correctly align the sump, the joint and the
metal strips. The dowels should have a thread size of M8 x 1,25, and should have a minimum length of 30 mm.
1 Clean the flange face of the cylinder block.
2 Install the four guide dowels, which have been manufactured locally, into the four corners (B1 and B4) of the
cylinder block face.
3 Apply beads of POWERPART Silicon sealing and jointing compound 6 mm (0.25 in) wide, as shown in (B) to:
l
the timing case (B5)
l
the rear oil seal housing (B2)
l
around the cup plugs (B3).
Caution: Do not apply the sealant more than five minutes before the sump is to be fitted to the engine.
4 Put the joint (A1) onto the sump, with the bead of sealant toward the cylinder block.
5 Put the sump and the joint in position over the guide dowels, support the sump.
6 Put the metal strips (A5) in position against the sump. Fit 10 of the long setscrews through the metal strips
and through the sump to secure them to the cylinder block. Tighten the setscrews finger tight.
7 Fit four of the short setscrews through the sump and into the timing case. Tighten the setscrews finger tight.
8 Fit the other four short setscrews through the sump and into the rear oil seal housing. Tighten the setscrews
finger tight.
9 Remove the guide dowels.
Continued
Consumable products
Description Part number
POWERPART Silicon RTV sealing and
jointing compound
1861108
W061
A
1
2
3
4
5
W066-1
B
1
2 5
3
4
4
This document has been printed from SPI². Not for Resale