PerkinElmer Raman Micro 200 Series, Руководство по началу работы

Страница: 24 / 114

24 . RamanMicro 200 Series Getting Started Guide
•
Use protective laser safety goggles, with an OD (optical density) of at least 3 at 785 nm,
as a precaution against accidental exposure to the direct or reflected laser light. Suitable
goggles are available from PerkinElmer (part number L1323518).
•
Ensure that the attenuator cap is attached.
Triggered Fiber Optic Probe Safety
When attached to the RamanMicro 200, a triggered fiber optic probe (TFOP) provides a
focused beam of Class 3B laser radiation. During normal operation, laser radiation is
accessible from the end of the probe.
The following precautions must be observed at all times:
•
Keep the protective cover in place on the probe tip when the probe is not in use.
If you are using the TFOP with a plastic spacer, always rotate the spacer so that the
screw is beneath the probe barrel when not in use; when in this position the spacer acts
as a lens cap.
• Never look directly into the laser beam or at the laser light scattered from a reflective
surface or sample. Permanent eye-injury may result. Do NOT attempt to examine the
probe tip when the Path Active light on the probe is lit.
•
Post warning signs near the laser operating areas.
•
Controlled access areas, limited to individuals trained in the safe operation of lasers, are
suggested for laser operations.
•
When the probe is in use, always ensure that no stray laser radiation is directed at
people in the vicinity.
• Use protective laser safety goggles, with an optical density (OD) of at least 3 at 785 nm,
as a precaution against accidental exposure to the direct or reflected laser light. Suitable
goggles are available from PerkinElmer (part number L1323518).
•
Do not use the TFOP if it shows any sign of damage.
•
If repair or servicing is needed, call your PerkinElmer Service Representative for advice.
For further safety details, see the
Raman Triggered Fiber Optic Probe leaflet (L1321887)