PerkinElmer Raman Micro 200 Series, Руководство по началу работы

Страница: 16 / 114

16 . RamanMicro 200 Series Getting Started Guide
Electrical Safety
The spectrometer module comes assembled within a protective housing to prevent exposure
to electrical hazards. There are also a number of exterior service panels that you should
remove only if you are cleaning the air filters. For more information see
Cleaning the Air
Filters on page 105.
Electrical Protection
Insulation: Class I rating for external circuits. Only connect equipment that meets the
requirements of IEC 61010-1, IEC 60950 or equivalent standards.
Power Supplies
The RamanMicro 200 is powered by one external PSU (Figure 1). The PSU used with the
spectrometer module can adjust automatically to a variety of AC power sources as outlined in
Table 1. For information on line frequency and current please review the rating plate on the
PSU.
Table 1 PSU input voltages and mains fluctuations information
Input Voltage Mains Fluctuations
100– 240 VAC ±10% of the nominal voltage
WARNING
Under no circumstances should you attempt to disassemble the PSU and
carry out repairs. If the PSU has a fault, please contact your PerkinElmer
Service Engineer. The entire unit must be replaced.
Connect the PSU to a three-wire (live, neutral and ground/earth) socket. The ground must be
a non-current carrying wire that is connected to the earth ground at the main distribution
box. The power point (socket) for the instrument PSU should be easily accessible for when
the instrument is serviced.
WARNING
Check the line voltage and frequency of the power point (socket) before
the instrument is connected or the power is switched on. This should be
carried out prior to the installation of the instrument and at any time the
instrument is plugged into a different power point (socket).