Assembly and Operation Manual
8
Figure 3 – The CLB
6.3. Control over the TB-01 turnstile
6.3.1 The turnstile can be operated from the following control devices:
RC panel;
Wireless
remote
control;
ACS
controller.
The above devices can be connected to the turnstile as follows:
any device alone;
in any combination with each other;
all devices simultaneously (in parallel).
Note
. At parallel connection of the above devices to the turnstile the superposition of
the control signals from them may occur. In that case the turnstile response will
conform to response to the obtained combination of input signals. (Appendices B
and C).
6.3.2 Connection of the devices mentioned in Clause 6.3.1 is made with
cables (17, 19, 20) to the corresponding connector blocks “XT1.L” and
“XT1.H” of the CLB in accordance with the connection layout (Ref.
Fig. A.1 Appendix A).
6.3.3 The RC panel is connected to the contacts “GND”, “Unlock A”, “Stop”,
“Unlock B”, “Led A”, “Led Stop” and “Led B” of the “XT1.L” connector
block.
6.3.4 The wireless remote control is connected to the contacts “GND”,
“Unlock A”, “Stop” and “Unlock B” of the “XT1.L” connector block.
Power supply of the wireless remote control is connected to the contact
“+12V” of the “XT1.H” connector block.
6.3.5 The ACS controller outputs are connected to the contacts “GND”,
“Unlock A”, “Stop” and “Unlock B” of the “XT1.L” connector block.
6.3.6 The ACS controller inputs are connected to the contacts “Common”,
“PASS A”, “PASS B”, “Ready” and “Det Out” of the “XT1.H” connector
block.
