Assembly and Operation Manual
14
Figure 5. Floor anchor position and cable entries (A) for IC-03.1 housing installation
Figure 6. Base bottom view:
central hole Ø30 mm is intended for cables entry
4. Prepare the electric raceways and mounting holes for the card capture reader
installation. Set the anchors all the way down the prepared holes.
5. Take out the container (9) (see Section 10.4).
6. Carefully lift up the cover (4) fixed to the framework with pressure pads and while not
disconnecting the reader cable move the cover in order to provide access to two
screws that fix the housing (3). Loose the screws, take off the housing (3) from the card
capture reader.
7. Place the card capture reader down on the mounting surface so that its base (1) was
near
A
zone (see Figure 5).
8. Pull cables (10), (11) and (12) through the central hole (Ø30 mm) in the base (see
Figure 6) inside the card capture reader and further up along the housing to the control
board. The length of the cables that remain inside the card capture reader after their
pulling should be enough for their further connection. It is recommended to secure all
cables on the internal sides of the base (1) and framework (2) with cable ties
1
1
Cable ties and self-adhesive cable tie mounts are not included in the set of delivery
and self-
adhesive cable tie mounts
1
.
