Pentair SPEEDEO SB-PF-SPO-003C, Инструкция по установке и эксплуатации

Страница: 17 / 32

SPEEDEO
®
VA R I A B L E S P E E D P U M P
VALID ESC
*
16:03 Water:+26.3°C
*
Filtration: ON
RedOx: 061mV
Air:+25.0°C pH: 7.2
Information about the
OS version
Choice between French
and English
Choice between the 14
lighting modes
See p12-13 (this menu is not available if a SOLEO is linked)
See p11
See p17-18
See 13 (this menu is not available if a SOLEO is linked)
See p14 (accessible via Install )
See p15 (accessible via Install )
See p19 (accessible via Install )
See p10
The Install menu menu is active.
It automatically deactivates after 15 mins of inactivity.
-Filtration length
Filtration speed
Filter washing
Inputs
Outputs
-Setting the time
Temperatures
Information
Languages
Update
Radio
Lighting
SPEEDEO v2
Version : 2.0
pentairpooleurope.com
SPEEDEO controls the equipment in the technical room, and the wrong settings may have serious
consequences for the safety of the pool. Because of this, access to certain initial configuration
functions is reserved for professionals, or people whose experience enables them to modify these
parameters while being fully aware of the consequences. In
order to limit accidental access, the Install menu menu has
secured access. (from the main menu, simultaneously hold
down Esc and Valid for 3 secs. A star appears in the top right
corner of the home screen).
Access to restricted access mode 'Install'
Menu organisation / Heating menu / Information menu
-Heating pump
Calibration
Antifreeze : +3°C
-LANGUAGE : French -Mode : Californian
-Heating pump: AUTO
Set point : 30°C
Priority : NO
CALIBRATION
-Temp. Water : +23.2°C
-Temp. Air : +23.3°C
Below this temperature, the filtration runs 24/7 to prevent the pool from freezing (active wintering).
- If the air temperature probe is connected: it becomes the reference value for freeze protection management. Place it
outdoors, out of direct sunlight so that the measurements are not distorted (see p06). - If the air temperature probe is not
connected: the water temperature becomes the reference value for freeze protection management. Please check that the
technical room is not heated or has a significantly different temperature in comparison with the temperature outside. If this is
the case, the difference must be compensated by Calibration .
This setting makes it possible to deliberately correct any
difference with another reference thermometer.
AUTO Activate the heating pump until the set point value has
been reached. Priority: NO Make sure the heating pump
does not start until the filtration is already running. Priority:
YES Start filtration so that the heating can function.
01:03 Water :+24.3°C *
Filtration: V2
S1:OFF S2:ON S3:OFF
AIR:+25.9°C
15