Pentair Pool and Spa Control System SunTouch, Инструкция по установке и эксплуатации

Страница: 12 / 88

4
SunTouch Pool and Spa Control System Installation and User’s Guide
SunTouch Main Status Screen (Solar Only)
The SunTouch “Solar Only” main status screen display description is given below.
AIR 85°F
11:51 AM
Lower current set point
temperature setting
AIR temperature: In “Solar Only” mode the
main screen toggles the display between the
current AIR temperature and the actual and set
point water temperature. The SunTouch system
time also displays as set in the “Time Set”
menu. In order to display the air temperature,
an optional air sensor is required. The air
sensor can be enabled and disabled from the
“Solar Only” menu.
Use Up/Down
buttons for menu
navigation only
(see “Up and down
arrow button”
on page 3).
SunTouch Control Panel (Solar Only mode)
SunTouch Solar Only System
The SunTouch “Solar Only” system is factory ready and to operate. From the main menu you can adjust the
water temperature setting, set the start and stop differential temperatures, and set the solar and cleaner freeze
protection feature. If additional features are required, such as a solar booster pump, you can access the “Pool/
Spa” mode (shared equipment) menu features. For more information about these modes, refer to “Solar Only
Menus,” on page 6, and “Pool/Spa Mode Menus (Shared Equipment)” on page 12.
WATER 77°/ 90°F
11:51 AM SOL ON
Water temperature settings: Displays the
actual (77°F) and set point (90°F) water
temperature. Adjust the water temperature
in “Set Water Temp” menu (page 6).
SOL ON : Displays when solar heat is
available and water is circulating through
the collector array. Solar heat is available
when the set point water temp is higher
than the solar temperature and the solar
temperature is higher than the actual
water temperature.
SOL OFF : Displays when solar heat is not
available (i.e. when the set point water
temp is lower than the solar
temperature and the solar temperature is
lower than the actual water temperature.
Raise current set point
temperature setting