Pentair EVERPURE CONSERV LT-S, Руководство пользователя

Страница: 19 / 20

19
EVERPURE
®
CONSERV
®
LT - S HIGH EFFICIENCY RO SYSTEM INSTALLATION AND OPERATION GUIDE
Limited Flow at the Application Equipment Valve
1. Turn OFF water supply to processor.
2. OPEN the application valve to turn on flow.
3. Unscrew the blue cap on the side of the Storage Tank to
expose air valve. Use a small air compressor or bicycle
pump to slowly add air to the storage tank. This will
force the water out of the storage tank through the valve.
Continue to slowly add air until water stops coming out
of the valve.
4. Turn OFF the application equipment valve.
5. Using an air pressure gauge, adjust the pressure in the
storage tank to 5-7 psi (0.34 bar, 0.034 MPa).
6. Replace the blue cap.
7. OPEN the incoming water valve until it comes to a stop.
Let the processor run one (1) to three (3) hours to fill the
tank. A full tank weighs approximately 32 lbs (14.5 kgs)
pounds. If performance has not improved, call
Technical Support.
Sudden Return of Taste and Odor
If shortly after complete servicing, noticeable taste and odors
return, contact Technical Support.
NOTES
If you are experiencing a problem not listed in this manual,
shut OFF the water supply and CLOSE the tank valve. Call
Technical Support.
Check for compliance with state and local laws and
regulations.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system.
For installations in Massachusetts, the Commonwealth of
Massachusetts Plumbing Code 248 CMR shall be adhered
to. Consult your licensed plumber for installation of the
system. This system and its installation must comply with
state and local regulations.
Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
Substances that may be reduced are not necessarily in your
water. Filter must be maintained according to manufacturer’s
instructions, including replacement of filter cartridges.
The efficiency rating for this system is 56.31%. Efficiency
rating means the percentage of the influent water to the
system that is available to the user as reverse osmosis
treated water under operating conditions that approximate
typical daily usage.
The tested recovery rating is 63.02%. Recovery rating means
the percentage of the influent water to the membrane portion
of the system that is available to the user as reverse osmosis
treated water when the system is operated without a storage
tank or when the storage tank is bypassed.
Daily Production Rate: 70 gpd (265 Lpd).
This reverse osmosis system contains a replaceable
component critical to the efficiency of the system.
Replacement of the reverse osmosis component should
be with one of identical specifications, as defined by the
manufacturer, to ensure the same efficiency and contaminant
reduction performance.
REPLACEMENT PARTS
Contact your local Pentair
®
Everpure Dealer for filter
cartridges or system replacement parts.
Description Part Number
GRO-75EN RO Membrane Cartridge
4002575
4FC5 Filter Cartridge
EV9693-21
4CC Mineral Cartridge
EV9627-45
Storage Tank EV3146-98
TDS Meter EV3125-98
Port Plug
EV3108-76
Waste Water Restrictor
EV3128-31
Conserv LT-S Cartridge Kit
EV9976-25
Conserv LT-S Tested and Certified by NSF
International against NSF/ANSI 58 for
the reduction of claims specified on the
Performance Data Sheet and at NSF.org.
Water Treatment
Appliance - E359339