EASYTOUCH
®
PL4/PSL4 Control Systems User’s Guide
25
Setting up Lights
(Continued)
From the Lights screen you can manually switch all lights on or off, synchronize colored lights, and activate
color light shows. Up to three (3) light circuits can be configured from the “Config” light menu. Each light must
have its own relay and separate circuit.
Setting up IntelliBrite Light Circuits
Before configuring the lights, be sure the auxiliary (AUX) circuits that control the IntelliBrite
®
Lights have
been assigned as an “IntelliBrite” light. For more information about “Circuit Functions” (page 44) and “Circuit
Names,” (page 45).
Lights Menu
To access the Lights menu screen, press
Menu > Lights
. The Lights menu settings are: MODES, COLORS,
ALL ON, ALL OFF, SYNC, MAGICSTREAM, CONFIG:
MENU
s
LIGHTS
w
LIGHTS
Modes (IntelliBrite Color light shows, Color Swim, Color Set)
To access the Modes menu, press
Menu > Lights > Modes
. There are six pre-programmed color light shows
to choose from. From the “Modes” screen you can select various preset show color lighting effects, such as
“American mode” and “Sunset mode”, “Color Swim” or “Color Set.” Using the “Hold” and “Recall” feature (see
page 26) you can also capture and save a unique color light show effect to recall at a later time.
The IntelliBrite color “Mode” settings light shows are:
•
Party:
Rapid color changing building the energy and excitement
•
Romance:
Slow color transitions creating a mesmerizing and calming effect
•
Caribbean:
Transitions between a variety of blues and greens
•
American:
Patriotic red, white and blue transition
•
Sunset:
Dramatic transitions of orange, red and magenta tones
•
Royalty:
Richer, deeper, color tones
IntelliBrite Light: If the IntelliBrite light was not previously on, after selecting a color show mode, no
illumination will occur for up to ten (10) seconds (depending on the selection), then a white light will
momentarily illuminate, followed by the color show mode selection. If the light was previously on, selecting
the a color show mode button will momentarily illuminate the previously selected color before changing to the
selected color show.
Modes (Color Swim)
The Color Swim feature cycles through white, magenta, blue and green colors. Using IntelliBrite lights, Color
Swim emulates the S
Am
®
, S
AL
®
Color Swim feature.
IntelliBrite Light Color Swim/Color Set: If the light was not previously on, after selecting Color Swim, no
illumination will occur for approximately six (6) seconds followed by the selection. If the light was previously
on, after selecting the Color Swim feature, the previously selected color will momentarily illuminate, no
illumination will occur for approximately six (6) seconds followed by the selection.
From the Lights screen you can manually switch all lights on or off, synchronize colored lights, and activate
color light shows. Up to three (3) light circuits can be configured from the“Config” light menu. Each light must
have its own relay and separate circuit
