PB-1525 Wood Pellet Burner System: Installation and Operation Manual
Rev 1.0, OCTOBER 2011
Page 39 of 67
received instruction from their Certified Installer.
Filling at Initial system set up and post Certified Installer maintenance:
NOTE
Before loading pellets into the hopper or bin, run the auger
following the steps below to verify proper rotational direction of
the auger screw. If the auger is running opposite the required
direction, reverse the input lead on the auger motor running
capacitor to reverse the motor rotation. Refer to the motor
wiring schematic on the auger motor.
Place the controller in the Idle State either by powering up the system
without a demand for heat (Open Thermostat), or follow the steps below
to force the system into the Idle State:
1.)
Power the unit normally or in Technician Mode
2.)
As soon as the controller enters the Purging State, press and hold
the Disable button.
3.)
Once the unit has been Disabled, press the End button.
Once the unit is in the Idle State the controller interface button on the far
right will become the “Feed” control button (See Figure 3.1 Above).
Pressing and holding this button will run the auger.
Run the auger past the first few pellets that drop to ensure the entire
auger is full of pellets and there is a consistent flow of pellets from the
auger.
Filling after running the system out of pellets:
WARNING!
The act of filling the conveyor will cause the system to activate
and mechanical components to be put in motion. Prior to filling,
be sure that all systems are free and clear of obstruction to
reduce the risk of entanglement.
