Pella 818K0100, Руководство по установке

Страница: 8 / 16

of sealant into the three sill strike holes and install the three # 8 x 3" fl at head stainless
steel screws (provided) into the holes.
K. Shim between the frame and the rough opening at the head strike location and
at every frame anchor hole location.
Remove and replace head strike screws
with three #8 x 3" corrosion resistant screws
(provided) through the head strike, door
frame, shims and into the rough opening.
Note: For doors with no head strike check
head for pre-drilled installation holes. If
installation holes are present drill 1/8"
pilot in each installation hole and install a
#8 x 3" screw (provided).
L. On each hinge, starting at the top, insert
a corrosion resistant screw (#12 x 2-1/2" for
out-swing or #8 x 3" for in-swing; provided)
DOORS •
ALL
DOORS •
ALL
DOORS •
ALL
DOORS •
ALL
DOORS •
ALL
DOORS •
ALL
DOORS
into the open screw hole. Make sure the
screw passes through the shims and into the
structural framing.
M.
Check door operation.
Open and close
the door to check for proper operation.
Make sure the door will latch correctly.
Note: If there are any problems with
the operation, check to confi rm the
door frame is installed plumb, level
and square. If the reveal between the
door panel(s) and frame is not even,
adjustments may be made:
Doors WITHOUT adjustable hinges:
Plastic shims located behind the hinges
may be removed to adjust the reveal
between the door panel and door frame.
Additional hinge shims may be added
if required.
Adjustable
Hinge
Non-Adjustable
Hinge
Note: Doors with adjustable hinges will have a (+)(-) on the door panel hinge
leaf to indicate possible adjustments and doors without adjustable hinges
do not have adjustment indicators.
Adjustable hinges are not designed to make up for failure to install the door
frame correctly. Before adjusting hinges, confi rm the door is installed plumb,
level and square.
Interior
3K
3J
3K
3J
Interior
3L