ECP
300
EXPERT STEPPER
Page 10
OPERATION AND MAINTENANCE MANUAL
Rev. 01-20
Fig. 5:
Open the front of the panel by lifting it
and sliding the two hinges to the end
of their travel.
Fig. 6:
Bend the hinges and rotate the front
piece 180° downwards to access the
inside of the panel and disconnect the
connector of the electronic board.
Fig. 7:
Apply pressure to the sides of each
individual hinge to remove it from its
seat and completely remove the front
piece.
Fig. 8:
Using a screwdriver, press on the four
pre-marked holes in the bottom to
make the holes for fixing the electrical
panel.
CHAP. 3 - Installation
