ECP
300
EXPERT STEPPER
Page 8
OPERATION AND MAINTENANCE MANUAL
Rev. 01-20
STANDARD EQUIPMENT FOR ASSEMBLY AND USE
The
ECP300 EXPERT STEPPER
electrical panel, for assembly and use, is equipped with:
• 4 Seals, to be interposed between the fixing screw and the bottom of the case.
• 1 Operation and maintenance manual.
• 1 Wiring diagram.
• 1 Drilling template.
• 2 NTC 10K Probes 1% .
MECHANICAL ASSEMBLY OF THE PANEL
❑
Each panel is designed for wall mounting; choose an appropriate fastening
system depending on the weight of the panel and the type of wall.
❑
Install the equipment in places that respect its protection level.
❑
Keep the IP protection level of the equipment intact by fitting cable glands
and/or pipe glands with adequate characteristics.
❑
Install the equipment at a height that allows easy use and inside access by
the operator. The operator must not be in a dangerous situation when
operating on the panel. In any case, the height must be between 0.6 and 1.7
metres from the service floor.
❑
Install the equipment in an area away from heat sources and possibly
protected from atmospheric agents.
Below are the steps to perform a correct mechanical installation of the panel.
Fig. 1:
Lift the transparent protective door
of the general thermal magnetic
switch.
CHAPTER 3: INSTALLATION
3.2
CHAP. 3 - Installation
3.1
